beautypg.com

Configuring the rs232 port on the master switch – Allied Telesis AT-S25 User Manual

Page 55

background image

AT-S25 Version 1.4 User’s Guide

55

Configuring the RS232 Port on the Master Switch

The default settings for the RS232 port on the front panel of the Ethernet
switch are as follows:

❑ Baud rate: 9600

❑ Data bits: 8

❑ Stop bits: 1

❑ Parity: None

❑ Flow control: None

To change the settings for the RS232 port on the master switch, perform
the following procedure:

1. From the Main Menu, select the master switch.

Note

You must select the master switch to perform this procedure. Do not
select a slave switch.

2. From the Main Menu, select System Configuration.

The System Configuration menu in Figure 7 on page 39 is
displayed.

3. From the System Configuration menu, select Terminal Configuration.