Allied Telesis AT-S25 - Manual (Page 54)

54
5. Immediately press any key when you see the following prompt:
Hit any key to run diagnostics or to reload
system software
.
A menu is displayed.
6. Select D from the menu. The following warning message displays:
WARNING: This will erase all current
configuration data!
Continue? Y/N
7. Type Y for yes.
The system displays the following prompt:
All configuration data has been reset to
factory default values
.
8. Type B to boot the stack software.
The master switch will reset itself and run a series of self-tests,
which take a few seconds to complete. During the tests, the Fault
LED on the front of the switch will flash. Once the tests are
completed, the Fault LED will remain OFF.
The master switch begins a discovery process of the stack
topology, during which the number and types of switches that
constitute the stack are determined. This discovery process takes
approximately thirty seconds to complete. Once completed, the
stack will begin to forward packets.