Ag Leader ParaDyme Operation Guide - Manual (Page 56)

54 Ag Leader Integra and Versa Firmware Version 4.3 / Edge Firmware Version 5.1
Port A Configuration
The Port A Configuration option enables you to configure the Baud Rate for your NMEA message
output.
Note: Changing the Baud Rate on the NMEA Out screen also changes the Baud Rate as displayed
in the External Radio screen. See “Configure SIM” on page 57 . Port A can be used simultaneously for
the External Radio and NMEA Out, but both functions must use the same Baud Rate.
To configure the Baud rate:
1. Select the Port A Configuration item from the
scrolling list on the right and press the Change Baud
Rate button. The Available Baud Rates screen
appears.
2. Select a baud rate and press the check mark button.
The NMEA Out screen appears and your changes are
saved.
Port B Messages and Configuration
The procedures to enable and edit Port B messages is identical to those for Port A with the following
exception: We strongly recommend that you reboot the ParaDyme system when you turn ON Port B
messages for the first time and when you turn OFF all Port B messages.
Note: Port B is used only for NMEA Out. It is not used for the External Radio.
U
SING THE
C
ONNECTIONS
M
ENU
C
ELL
M
ODEM
The Cell Modem screen functions differently depending on whether you are using the factory-supplied
SIM or a customer-supplied SIM. The ParaDyme system automatically detects which type of SIM is
installed and displays the correct screens and functions with either type of SIM, the cell modem is used
to:
• enable initial system registration.
1 SPS Position SPS Position
2 DGPS Position Fixed Position (DGPS, OmniSTAR
or RTK)
3 N/A N/A
4 RTK Fixed Position N/A
5 RTK Float Position N/A
Value Current Version Legacy Version