Rtk connection type – Ag Leader ParaDyme Operation Guide User Manual
Page 43
41
Note:
Ensure the vehicle radio frequency is the same as the Base Station frequency. Also, the
Channel Spacing must match the settings of the transmitting radio. Setting the Channel spacing
value is only performed once or when the base station is changed. Communications will not operate
properly if the settings are not matched.
To use a previous frequency:
1. From the Frequency screen, press the Use
Previous button. The previously used frequencies list
appears.
2. Using the up and down arrows, select a frequency
and press the check mark button to return to the GPS
RTK menu.
RTK Connection Type
The RTK Connection Type screen enables you to select a method of connecting to RTK corrections. The
available options are:
• Internal Radio - Receives RTK corrections via the internal radio (either 900MHz or an AFLink) pre-installed
on the ParaDyme Roof Module.
• External Radio - Receives RTK corrections via a third party Radio connected externally to ParaDyme Roof
Module using the auxiliary cable. This option is used when you have an installed third party radio for
connection to a third party transmitter.
• NTRIP - Enables you to connect to GPS correction sources via a cell modem.
Note:
for additional information regarding NTRIP.
1. Press the RTK Connection Type item in the scrolling
list.
2. Press the up/down arrows to select an RTK
Connection Type, then press the Apply button. Your
RTK Connection Type is now set.