Ag Leader ParaDyme Operation Guide - Manual (Page 27)

25
1. The Antenna Calibration should only be performed
at the request of ParaDyme support personnel. The
Antenna Calibration procedure can take hours to
complete and you will not be able to operate your
vehicle during this time.Press the Reset Calibration
button to reset the antenna calibration.
SA Module (Sensor Actuator Module)
The SA Module connects the ParaDyme controller to
all AutoSteer sensors and actuators. The SA Module
receives sensor inputs from the Wheel Angle Sensor
and the AutoSteer steering valve pressure transducer
and outputs electrical signals to the AutoSteer steering
valve to steer the vehicle.
The SA Module screen provides an indicator showing
SA Module communication status, SA Module
firmware version and vehicle type.
Hydraulic Valve
The Valve Steering Diagnostics procedure is
performed in order to verify that your hydraulic setup is
operating correctly and to validate new installations.
WARNING: Before performing this test, ensure people and objects are clear of the vehicle. When
pressing the command buttons, the wheels move quickly from side to side. Press the STOP button
to halt the wheels.
To test steering valve performance: