HP Color LaserJet 9500 Multifunction Printer series - Manual (Page 39)

ENWW Loading input trays 23
1
1
Note
If the size displayed on the control panel is CUSTOM , then the tray size is set
to ANY CUSTOM . The tray will match any custom-size print job, even if the
print-job dimensions are different from the dimensions of the paper that is
loaded in the tray. If you prefer, you can specify the exact dimensions of the
custom-size paper that is loaded in the tray. When you specify exact
dimensions, the dimensions are displayed as the size, rather than
CUSTOM .
11 Touch C USTOM . The Unit of Measure menu is displayed.
Note
The MFP might prompt you to move the Custom/Standard switch in the tray
to another position. The MFP might also prompt you to move the paper
guides. Follow the instructions on the control panel, close the tray, and then
repeat this procedure starting with step 10.
12 Touch the unit of measure ( M ILLIMETERS or I NCHES ). (If you are using the
measurement on the tray guide, select M ILLIMETERS .)
13 Use the numeric keypad to select the X (front to back) dimension.
14 Touch O K .
15 Use the numeric keypad to select the Y (left to right) dimension.
16 Touch O K . The control panel displays SETTING SAVED for a moment. The
tray size in dimensions is then displayed.