HP Color LaserJet 9500 Multifunction Printer series - Manual (Page 252)

http://www.hp.com/go/clj9500mfp
236 Chapter 8 – Managing and maintaining Rev. 1.0
8 Remove the brush from the tongs by raising the snap on the back of the
brush and pulling the brush away from the tongs.
9 Replace the tongs and brush on the inside of the right door.
10 Using one hand to support the underside of the transfer roller, turn the roller
to a 45° angle and align the roller with the slot. Slide the roller into the slot
until it stops.
CAUTION
Do not touch the black foam roller, and be careful not to scratch the
underside of the image transfer belt as you insert the roller into the MFP.
11 Swing the green lever up, and then close the front doors.
Note
If the lever does not move freely, make sure that the transfer roller is
pushed into the MFP completely. See also “MFP hardware issues” on
page 290.
8
10
11