HP Insight Control Software for Linux - Manual (Page 39)

4.5.1.2 Log button in the target status area
When you select the Log button, a new window opens that displays the log for all operations
for the task, including the following information:
• A summary of the task level information
• The information displayed in the target status table for the selected target
• A block of information for each operation in the task, including the log
The log screen does not auto-refresh. It always shows the status information that was current at
the time you selected the Log button.
The Log button is disabled when the selected target is in the Pending state, because no log
information is available to be displayed. Pending operations do not have a log.
4.5.2 Target details table
Figure 4-8 illustrates the Target Status table, which lists the status for all targets on which a task
was run.
Figure 4-8 Target details table
The Target Details table lists the status for all operations for the target selected in the Target
Status table. The operations are shown in the table in the order in which they run. This table
cannot be resorted. The operations for all targets of a task are the same and are in the same order.
All tasks for the same Insight Control for Linux menu items have the same operations.
Table 4-3
describes the information displayed in the Target Details table.
4.5 SIM standard task results format 39