HP Insight Control Software for Linux - Manual (Page 207)

23 Miscellaneous topics
This chapter addresses the following topics:
• “Changing management processor credentials” (page 207)
• “Changing the default port for the repository web server” (page 207)
• “Increasing the number of servers that can be discovered concurrently” (page 208)
• “Changing the IP address of the CMS ” (page 208)
• “Uninstalling Insight Control for Linux” (page 208)
• “Determining the installed Insight Control for Linux version” (page 209)
• “Event logging overview” (page 209)
• “Changing the number of concurrent tasks” (page 210)
• “Support for HP ProLiant DL1xx series servers” (page 211)
• “Setting up the DHCP server for virtual guests” (page 211)
23.1 Changing management processor credentials
Select the following menu item from the HP Insight Control user interface to change the user
name and passwords for
iLO -based management processors:
Configure
→Management Processor→Credentials
You can set these credentials at a global level for all managed system s or set them on an individual
basis.
If you want unique credentials on an LO100-based server, you must set them manually. The
Configure
→Management Processor→Credentials only sets these credentials locally.
For more information on management processor credentials, see “Management Processor
Credentials” (page 213) .
23.2 Changing the default port for the repository web server
By default, the repository web server is configured to provide files on TCP port 60000.
NOTE: The default port for the repository web server is hard coded in the VMware ESX Kickstart
template files. If you want to change the port, you must manually replace all occurrences of
60000
with the new port number before performing the VMware ESX installation.
To change the default port, follow these steps:
1. Use a text editor to edit the following file:
/opt/mx/icle/icle.properties
2. Change the value of the REPOSITORY_HTTP_PORT attribute to an unused port that is
available and selected to run the repository web server.
3. Save your changes and exit the text editor.
4. If you have changed the port number for the repository web server, verify that the new port
is open on the CMS. One method is to use the nmap command.
5. Restart HP SIM by running the following commands:
# /opt/mx/bin/mxstop
# /opt/mx/bin/mxstart
Wait for two to three minutes for HP SIM to restart completely.
23.1 Changing management processor credentials 207