HP StorageWorks XP10000 Disk Array - Manual (Page 135)

4. Enter the desired numerical IP address in the IP Address text box ( Figure 94 ).
5. Click Set to add the new IP address. The new IP address is added to the IP Address list, but the
changes are not implemented until you click Apply.
6. If you want to apply the changes to the array, click Apply. Click OK on the confirmation message.
).
Figure 94 Adding SNMP Manager IP Address (Left: Before Setting. Right: After Setting)
Deleting SNMP Manager IP Addresses
To delete a SNMP Manager IP address:
1. Change to Modify mode.
2. Click Install (
3. Click the SNMP IP Security tab.
4. Left-click one or more unwanted IP addresses in the IP Address list box to select them. Right-click to
display the Delete IP Address pop-up command (see Figure 95 ).
5. Select the Delete IP Address command.
6. A confirmation message is displayed. Click OK to request the delete IP address operation(s), or
click Cancel to cancel.
7. If you want to apply the changes to the array, click Apply. Click OK. If you want to cancel the
changes, click Cancel.
HP StorageWorks 135