HP StorageWorks XP10000 Disk Array - Manual (Page 134)

register the system group information, the Extension SNMP check box must be clicked. When you
register the system group information, click Apply. The system group information is as follows:
• Name: Device name of the connected array. The device name can be changed. You can
use up to 180 alphanumeric characters for the device name; the following symbols cannot be
used: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, %,. You can use a space in the middle of the device
name, but do not use a space before or after the device name.
NOTE:
The device name is required to use SNMP Agent. Be sure to document the device name because
the settings will be cleared when the SVP is replaced.
• Contact: Contact information such as personnel and telephone numbers where you can
inquire about the connected array. Contact information can be changed using Modify mode.
You can use up to 180 alphanumeric characters (ASCII codes) for contact information; the
following symbols cannot be used: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %. You can use a
space in the middle of the contact information, but not before or after the contact information.
NOTE:
A contact name is required to use SNMP Agent. Be sure to document the contact name because
the settings will be cleared when the SVP is replaced.
• Location: Location of the connected array. The device location can be changed using Modify
mode. Follow these requirements: 1) Use up to 180 alphanumeric characters (ASCII codes)
when entering a device location. 2) Spaces can be used with the exception of before and
after the location name. 3) Some symbols cannot be used, such as ", \, ;, :, ,, *, ?, <, >,
|, /, ^, &, and %.
NOTE:
The device location is required to use SNMP Agent. Be sure to document the device location
because the settings will be cleared when the SVP is replaced.
• Apply: Implements the settings made on this pane.
This button is active only when you select Modify mode. You must also have the permission to apply
the settings.
• Cancel: Cancels the settings made on this pane.
SNMP Agent Operations
NOTE:
To set the SNMP Agent properties from the XP Remote Web Console, you must click the Extension
SNMP check box on the SNMP IP Security pane. You must have write permission to change the SNMP
Agent properties.
Adding SNMP Manager IP Addresses
To add SNMP Manager IP addresses:
1. Change to Modify mode.
2. Click Install ( ).
3. Click the SNMP IP Security tab ( Figure 93 ).
134 Setting SNMP Agent Properties