HP StorageWorks XP10000 Disk Array - Manual (Page 138)

Figure 98 Delete Community Pop-Up Menu
Changing a Community Name
To change a community name:
1. Change to Modify mode (see “ View Mode and Modify Mode ” on page 48 if you need instructions).
2. Click Install ( ).
3. Click the SNMP IP Security tab.
4. Select and then right-click the community name that you want to change in Community & Trap. The
Change Community popup menu is displayed (see Figure 99 ).
5. Select the Change Community command. The Change Community pane is displayed (see
Figure 100 ).
6. In the Community text box, overwrite the old community name with a new community name. You
can use up to 180 alphanumeric characters, except for ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %.
You can also use spaces, except at the beginning or the end of the name.
7. Click OK. The changed community name is displayed in the Community & Trap box, but the changes
are not yet implemented in the array.
8. If you want to apply the changes to the array, click Apply. Click OK.
138 Setting SNMP Agent Properties