HP StorageWorks XP10000 Disk Array - Manual (Page 136)

Figure 95 Delete IP Address Pop-Up Menu
Adding A Community Name
To add a community name:
1. Change to Modify mode.
2. Click Install ( ). Click the SNMP IP Security tab.
3. In the Community & Trap box, select and right-click on Community. The Add Community pop-up
menu is displayed (see Figure 96 ).
4. Select the Add Community command. The Community pane (see Figure 97 ) is displayed.
5. In the Community text box, enter the desired community name. You can use up to 180 alphanumeric
characters, except for ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %. You can also use spaces, except at
the beginning or the end of the name.
6. Click OK. The new community name is displayed in Community & Trap, but the changes are not yet
implemented in the array.
7. If you want to add one or more IP addresses to the new community, see
“ Adding Community IP Addresses ” on page 139.
8. If you want to apply the changes to the array, click Apply. Click OK.
136 Setting SNMP Agent Properties