HP Hitachi Dynamic Link Manager Software - Manual (Page 382)

366 Chapter 9 Messages
9.15 Messages from the dlmchkpath Utility for Checking HDLM Paths
Message ID Message Details and Actions
KAPL12401-I All LUs managed by HDLM are in a single
path configuration.
Details
This message is displayed when the number of
LUs managed by HDLM is 0.
Action
None.
KAPL12402-W iLU ( aa...aa ) is in a multi-path
configuration. PathID =
bb...bb [, cc...cc ]...
Details
The LU of the LU number in the message is not in
a single path configuration.
aa...aa : LU number
bb...bb,cc...cc : Path ID of the path
connected to the LU
Action
Before performing uninstallation, upgrade
installation, or re-installation, change the LUs to a
single path configuration.
KAPL12403-W A necessary parameter has not been
specified.
Action
Execute the dlmchkpath utility with the -h
parameter to check the parameter, and then retry.
For details on the dlmchkpath utility, see
section 8.5.
KAPL12404-W A parameter is invalid. Parameter =
aa...aa
Details
aa...aa : Specified parameter
Action
Execute the dlmchkpath utility with the -h
parameter to check the parameter, and then retry.
For details on the dlmchkpath utility, see
section 8.5.
KAPL12405-E Cannot execute the utility for checking
HDLM paths due to insufficient memory.
Details
The memory required for processing the
dlmchkpath utility could not be allocated.
Action
Terminate unnecessary applications to increase
the amount of free memory.
Alternatively, restart the host.