HP Hitachi Dynamic Link Manager Software - Manual (Page 118)

102 Chapter 3 Creating an HDLM Environment
An example of executing the dlnkmgr command's view operation is as follows:
>dlnkmgr view -sys
HDLM Version : xx-xx
Service Pack Version :
Load Balance : on(rr)
Support Cluster : off
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : off
Remove LU : off
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive xx-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive xx-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive xx-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name = view, completion
time =
yyyy/mm/dd hh:mm:ss
Even if you are using VCS, off appears for Support Cluster. Regardless, the cluster
support function runs normally.
23. Use the results of the view operation to check the version of the installed HDLM. When
05-91 is displayed in HDLM Version, the correct version of HDLM has been installed.
24. Use the results of the view operation to check that the programs are running properly. If
HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all programs
are running correctly.
25. After installation finishes, check the path information as described in section 3.7, and
make sure that you have successfully installed HDLM in a single-path configuration.
26. Connect cables to all HBAs (multi-path configuration).
27. Check the path information as described in section 3.7 to make sure that you have
successfully built a multi-path configuration.