HP Hitachi Dynamic Link Manager Software - Manual (Page 128)

112 Chapter 3 Creating an HDLM Environment
To change the integrated trace file settings:
1. In Explorer, double-click the following file:
program-installation-destination-drive :\Program
Files\HITACHI\HNTRLib2\bin\hntr2utl2.exe
The Hitachi Network Objectplaza Trace Utility 2 Release 2.0 dialog box shown in Figure
3.5 appears.
Figure 3.5 Hitachi Network Objectplaza Trace Utility 2 Release 2.0 Dialog Box
2. In Number of Files, change the number of integrated trace files. The default is 4. You
can specify a value from 1 to 16. The value you specify here will apply to n in program-
installation-destination-drive:\Program Files\HITACHI\HNTRLib2\
spool\Hntr2n.log (n indicates a file number).
3. In File Size(KB), change the size of an integrated trace file. The default is 256
(kilobytes). You can specify a value from 8 to 8192. Specify a value greater than or equal
to the setting of Buffer Size(KB).
4. In Buffer Size(KB), change the buffer size. Change the buffer size for the monitoring
cycle. The default is 64 (kilobytes). You can specify a value from 8 to 2048. Specify a
value smaller than or equal to the setting of File Size(KB).
5. In Interval Timer(KB), enter a value to shorten the monitoring cycle. The default is 10
(seconds). You can specify a value from 1 to 300.