HP Hitachi Dynamic Link Manager Software - Manual (Page 296)

280 Chapter 8 Utility Reference
Error
Information File How to Obtain Files 1
MPIO
information
mpio-list.txt At the command prompt, execute the mpiolist command
listed below to output the results into the mpio-list.txt
file:
„ HDLM-installation-drive : \Program
Files\HITACHI\DynamicLinkManager\DLMTools
\mpiolist 0 > mpio-list.txt
„ HDLM-installation-drive : \Program
Files\HITACHI\DynamicLinkManager\DLMTools
\mpiolist 1 >> mpio-list.txt
„ HDLM-installation-drive : \Program
Files\HITACHI\DynamicLinkManager\DLMTools
\mpiolist 2 >> mpio-list.txt
„ HDLM-installation-drive : \Program
Files\HITACHI\DynamicLinkManager\DLMTools
\mpiolist 3 >> mpio-list.txt
„ HDLM-installation-drive : \Program
Files\HITACHI\DynamicLinkManager\DLMTools
\mpiolist 4 >> mpio-list.txt
„ HDLM-installation-drive : \Program
Files\HITACHI\DynamicLinkManager\DLMTools
\mpiolist 5 >> mpio-list.txt
Windows
system
information
winmsd.txt
At the command prompt, execute the winmsd
command as follows. The winmsd.txt file is
output to the folder where you execute the
command: winmsd /report winmsd.txt
All the folders
and the list of
files in the
Windows
installation
destination
folder
dirSystemRoot.txt
At the command prompt, execute the following
command to output the results into
dirSystemRoot.txt file: dir /s /a
%SystemRoot% > dirSystemRoot.txt
1 The installation folders used in the How to obtain the files column indicate the default installation folder.
2 In the actual file name, a file number is appended to Integrated - trace-file-prefix specified-in-the-
Hitachi-Network-Objectplaza-Trace-Library-utility2 . For example, the default is hntr21.log to
hntr216.log . Note that the 2 following the integrated trace file prefix does not represent a file number.
3 In the Windows Server 2003 (IPF and x64), replace this part with Program Files (x86) .
4 You can obtain dlm_iscsims.txt only when the iSCSI software was installed.