HP Hitachi Dynamic Link Manager Software - Manual (Page 315)

HiCommand ® Dynamic Link Manager (HDLM) for Windows ® Systems User’s Guide 299
Message ID Message Details and Actions
KAPL01055-I All the paths which pass the specified aa...aa
will be changed to the Offline(C) status. Is this
OK? [y/n]:
Details
Multiple paths will be collectively placed
Offline(C) because the -hba or -cha
parameter was specified. To collectively place
multiple paths Offline(C), enter y . To not
collectively place them Offline(C), enter n .
aa...aa : cha port or hba
Action
If you want to execute the offline processing for
the paths that pass the specified target, enter y .
If you want to terminate the processing, enter n .
KAPL01056-I If you are sure that there would be no problem
when all the paths which pass the specified
aa...aa are placed in the Offline(C) status,
enter y. Otherwise, enter n. [y/n]:
Details
This message re-asks the user whether to place
all the paths Offline(C). To place all the paths
Offline(C), enter y . To not place them
Offline(C), enter n .
aa...aa : cha port or hba
Action
If you want to execute the offline processing for
the paths that pass the specified target, enter y .
If you want to terminate the processing, enter n .
KAPL01057-I All the paths which pass the specified aa...aa
will be changed to the Online status. Is this OK?
[y/n]:
Details
Multiple paths will be collectively placed Online
because the -hba or -cha parameter has
been specified. To continue processing, enter
y . To cancel processing, enter n .
aa...aa : cha port or hba
Action
If you want to execute the online processing for
the paths that pass the specified target, enter y .
If you want to terminate the processing, enter n .
KAPL01058-W The specified parameter value is not needed.
Operation name = aa...aa , parameter =
bb...bb , parameter value = cc...cc
Details
A parameter value was specified in a parameter
that does not need any parameter value.
aa...aa : clear , offline , online , set ,
view
bb...bb
: Parameter name
cc...cc : Parameter value
Action
Execute help operation-name of the HDLM
command ( dlnkmgr ) to check the parameter
and parameter value, and then retry. For details
on the help operation, see section 7.3.