HP Hitachi Dynamic Link Manager Software - Manual (Page 313)

HiCommand ® Dynamic Link Manager (HDLM) for Windows ® Systems User’s Guide 297
Message ID Message Details and Actions
KAPL01045-W Too many parameter values are specified.
Operation name = aa...aa , parameters =
bb...bb , parameter value = cc...cc
Details
aa...aa : offline , online , set , view
bb...bb : Parameter name
cc...cc : Parameter value
Action
Execute help operation-name of the HDLM
command ( dlnkmgr ) to check the parameter
value, and then retry. For details on the help
operation, see section 7.3.
KAPL01046-I An offline request was registered in a batch job.
PathID = aa...aa
Details
The offline command was executed but the
path is currently processing. If the view -path
operation is executed in this status, Offline(P) is
displayed. Wait a while, and then re-execute the
view -path operation to make sure that the
status is Offline(C).
aa...aa : Path ID (decimal number)
Action
None.
KAPL01047-W Only one offline request can be registered in a
batch job.
Details
The offline command cannot be accepted
because offline processing is currently being
performed.
Action
Wait until the offline request registered in the
batch job finishes, and then retry.
KAPL01048-W Help information cannot be found. Operation
name = aa...aa .
Details
The specified operation is not an operation of
the HDLM command.
aa...aa : Specified operation name
Action
Use the help operation of the HDLM command
( dlnkmgr ) to check the operation name. And
then retry. For details on the help operation,
see section 7.3.
KAPL01049-I Would you like to execute the operation?
Operation name = aa...aa [y/n]:
Details
The clear / set operation will be started. To
continue the operation, enter y . To cancel the
operation, enter n .
aa...aa : clear , set
Action
If you want to execute operation of the HDLM
command, enter y . If you want to terminate the
processing, enter n . For details on the clear
operation, see section 7.2. For details on the
set operation, see section 7.6.