HP Hitachi Dynamic Link Manager Software - Manual (Page 276)

260 Chapter 7 Command Reference
Parameters for Displaying LU Information by Adding Items to be Displayed
In the -lu –item parameter, the items specified with the -item option are added to the
items to be displayed by the -lu option and displayed. If no value or all is specified for the
-item parameter, all the items that can be added are displayed.
Table 7.14 shows the items that can be added by using the -item parameter and the
parameters that can be specified after the -item parameter.
Table 7.14 Items Added Using -item Parameter and Parameters Specified After –item Parameter
Item Added Subsequent Parameter
SLPR slpr
PathName pn
ChaPort cp
CLPR clpr
Type type
IO-Count ic
IO-Errors ie
DNum dnu
IEP iep
All items are displayed all
In the subsequent sub-parameters (-hdev or -pathid), you can filter the LU information to
be displayed. When you omit both parameters, the command displays the information about
all the LUs recognized by HDLM.
For details on the contents of each displayed item, see Table 7.15.
The subsequent sub-parameters are:
„
-hdev host-device-name: Filters the information only for the paths accessing the
specified host device. Specify a drive letter to indicate the desired host device. You
cannot specify the host device unless a drive letter has been assigned. The host-
device-name string is case-sensitive. If the command ended by displaying the
KAPL01064-W or KAPL01013-E messages, follow the steps recommended in the message.
„ -pathid AutoPATH_ID: Use this parameter to display only the information about the
LU to which the path with the specified AutoPATH_ID is connected.