HP Hitachi Dynamic Link Manager Software - Manual (Page 312)

296 Chapter 9 Messages
Message ID Message Details and Actions
KAPL01035-W The cluster support function is active, so the
load balancing function is not supported.
Details
The load balancing function cannot be enabled
because MSCS is installed.
Action
The load balancing function is not supported in
an environment with MSCS installed. If you
want to use the load balancing function,
uninstall MSCS.
KAPL01036-E The Offline path cannot be placed online.
PathID = aa...aa
Details
The path could not be recovered.
aa...aa : Path ID (decimal number)
Action
Remove the error in the path, and then retry.
KAPL01039-W During the online operation processing of the
HDLM command, a path that cannot be placed
in the Online status was detected. PathID =
aa...aa Would you like to continue the
processing of the online operation? [y/n]:
Details
A path that cannot be placed Online was
detected during multi-path online processing.
To ignore this path and perform online
processing for the next path, enter y .
To cancel processing, enter n .
aa...aa : Path ID (decimal number)
Action
If you want to continue processing of the
online operation of the HDLM command for
other paths, enter y . If you want to terminate
the processing, enter n . For details on the
online operation, see section 7.5.
KAPL01040-W The entered value is invalid. Re-enter [y/n]: Details
A value other than y and n was entered. Enter y
or n.
Action
Enter y or n .
KAPL01041-E The entered value is invalid. The operation
stops. Operation name = aa...aa
Details
Command processing will be aborted because
an incorrect response was made three times in
reply to the request.
aa...aa : clear , offline , online , set
Action
To execute the operation, re-execute the HDLM
command.
KAPL01044-W A duplicate parameter value is specified.
Operation name = aa...aa , parameter =
bb...bb , parameter value = cc...cc
Details
The same parameter value is specified two or
more times.
aa...aa : view
bb...bb : Parameter name
cc...cc : Duplicated parameter value
Action
Delete the duplicate parameter value name,
and then retry.