HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 130)

Server management 130
The screen can be edited only by users with server privileges, but it is viewable by all authorized users.
The following table describes the fields within the Edit Server Profile screen.
Column name Description
Profile
Profile Name Descriptive name for the server profile. Do not use spaces.
Status Status of the server profile
Ethernet Adapter Connections
(Physical ports)
Port Relative order of the Ethernet port on the server receiving the profile. System
board NICs are first in the order, followed by NICs on mezzanine cards.
Network Name Name of the network associated with this port, selected from a list of defined
networks
Status Status of the network
Port Speed The requested operational speed for the server port. Valid values include
"Auto", "Preferred", and "Custom".
If the speed type is "Auto", the maximum port speed is determined by the
maximum configured speed for the network.
If the speed type is "Preferred", the speed of the network is the same as the
preferred speed of the network to which the connection is associated. If no
preferred speed is configured for a network, it defaults to "Auto".
If the speed type is "Custom", the user can configure any speed from 100-Mb
to MAX Configured speed for the network in 100Mb increments.
Allocated Bandwidth Allocated bandwidth of the port. See "Bandwidth assignment (on page
107 )".
PXE Enables or disables PXE on the network connection. Valid values are
"enabled", "disabled", and "UseBios". If this value is not specified, the