HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 117)

Server management 117
You might need to update the BIOS on the mezzanine card for iSCSI to work. For more information on the
BIOS as well as additional support hardware, see the QuickSpecs on the HP website ( http://www.hp.com ).
The following table describes the fields within the Flex-10 iSCSI connections screen.
Item Description
iSCSI Boot
Configuration
Initiator Name Name used for the iSCSI initiator on the booting system. The initiator name length can
be a maximum of 223 characters.
Target Name Name of the target from which to boot. The target name length is a maximum of 223
characters.
Boot LUN The LUN of the target identifies the volume to be accessed. Valid values for standard
LUNs are 0-255 decimal. Valid values for extended LUNs are 13- to 16-character
hexadecimal values.
Target Primary IP
Address Primary IP address used by the iSCSI target
Target Primary Port The TCP port associated with the primary target IP address. The default value is 3260.
Target secondary IP
Address
Alternate target IP address to use if the primary port is unavailable
Target secondary Port The TCP port associated with the secondary target IP address. The default value is
3260.
Initiator Network
Configuration
VLAN id The VLAN number that the iSCSI initiator uses for all sent and received packets. Valid
values range from 1 to 4094.
Netmask IP network mask used by the iSCSI initiator. This value is in dotted decimal format.
Gateway Default IP route used by the iSCSI initiator. This value is in dotted decimal format.
Authentication Method
CHAP (one-way)
One-way Challenge-Handshake Authentication Protocol. The authentication protocol