Software service tool – KROHNE ALTOSONIC V12 EN User Manual

Page 47

SOFTWARE SERVICE TOOL

ALTOSONIC V12

www.krohne.com

04/2013 - 4002643502 - MA ALTOSONIC V12 R02 en

Variables can be added to the list of values to be collected from the meter and become available
for presentation:

Step 5:

Step 5: Open the tree structure in the left panel, and select the variable name to be added to the
list.

Step 6:

Step 6: Click the button pointing to the right in the center panel. The item will now appear in the
list in the right panel.

Similarly variables can be deleted from the list of values to be collected from the meter, these
values will no longer be available for monitoring / logging.

Step 7:

Step 7: In the right panel, click in the box to the left of the name/description of the variable to be
deleted, the pointer will not move to this line. This will also enable the button in the center panel
with the arrow pointing to the left.

Step 8:

Step 8: Click on this button to remove the selected item from the list.

Step 9:

Step 9: Click the button in the centre panel with the double arrow to the left to clear the list
completely.

Step 10:

Step 10: Click the button “Close” in the centre panel to finish this part: Monitoring List editor
screen will disappear, Returning to the “Monitoring Configuration Window”.

You can adjust the rate at which the selected data will be sent and updated:

Step 11:

Step 11: Click the “down”- arrow left of “Interval in sec.”

Step 12:

Step 12: Click on the rate according to your preference.

Step 13:

Step 13: Click the “Close” button in the lower right corner of this window to finish this part. A
dialog box will ask if you want to (re)start the monitoring process.

Figure 7-20: Monitoring configuration