KROHNE ALTOSONIC V12 EN - Manual (Page 41)

SOFTWARE SERVICE TOOL
7
41
ALTOSONIC V12
www.krohne.com 04/2013 - 4002643502 - MA ALTOSONIC V12 R02 en
1. To confirm the selection, click on the arrow in the most left field of the row with the meter se-
lected by default.
2. To select another meter: move the arrow to the row with the meter you want to communicatie
with, click in the most left field of the row showing the meter.
3. Confirm your choice by clicking OK.
In case that you do not get a response from any meter or you don’t get a response from the
meter you want to communicate with. Reasons can be:
• there is no ultrasonic flowmeter operational, or
• the meter you want to communicate with is not connected to a power source, or
• the communication line is not properly connected.
If this happens you can press the button “Rescan” after the problem is solved. MCST will now
resend the message, asking for a response from any meter that is able to communicate using
the selected communication method. If the problem has been solved properly, the meter that
you are looking for will be listed in the dialog box.
You have now selected a communication method and a meter. The selected communication
method and flowmeter address will now appear in the respective information fields in the status
bar at the bottom of the screen.
Type your name and password in the dialog box and click OK.
Figure 7-7: Select the device
Figure 7-8: Selection at the bottom of the screen