Modbus protocol description and set-up – KROHNE ALTOSONIC V12 EN User Manual
Page 139
![background image](/manuals/369187/139/background.png)
MODBUS PROTOCOL DESCRIPTION AND SET-UP
10
139
ALTOSONIC V12
www.krohne.com
04/2013 - 4002643502 - MA ALTOSONIC V12 R02 en
Flowmeter configuration
Relative
address
Absolute address
Name
Parameter /
Variable
(short description)
non-Modicon
Modicon-comp.
1
7501
7502-7503
(2 regs)
Diameter
Internal diameter
Internal diameter of meter body at the
measuring section (in m).
2
7502
7504-7505
(2 regs)
MeterConstat_Fwd
Meter constant
forward
Meter constant, forward flow direction.
3
7503
7506-7507
(2 regs)
MeterConstant_Rev
Meter constant
reverse
Meter constant, reverse flow direction.
4
7504
7508-7509
(2 regs)
ThermExp_Alpha_Pip
e
Thermal expansion
factor
pipe material Alpha
Property of the material of the meter body,
used to calculate the effect of themal
expansion (in 1/° C)
5
7505
7510-7511
(2 regs)
ThermExp_Reference
_Temp
Reference
temperature
Body expansion
Temperature (in ° C) at which the internal
diameter of meter body at the measuring
section is specified.
6-11
7506-7511
(6 regs)
7512-7523
(12 regs)
Ch_PathLength_Cal
Channel Calibrated
Path
Length L,
channel 1-6
Length (in m) of acoustic path length between
two transducers of a measuring path; array
with values for channel 1 through 6.
12-17
7512-517
(6 regs)
7524-7532
(12 regs)
Ch_Angle_Measuring
Channel Measuring
Angle
channel 1-6
Angle at which the ultrasonic beam intersects
with the meter body (in Deg); array with values
for channel 1 through 6.
18
7518
7536-7537
(2 regs)
Fwd_MaxFlowRate
Flow Full Scale
Forward
Indicated value (in m
3
/s) (full scale) at flow of
100 % of rated volume flow in forward flow
direction.
19
7519
7538-7539
(2 regs)
Rev_MaxFlowRate
Flow Full Scale
Reverse
Indicated value (in m
3
/s) (full scale) at flow of
100 % of rated volume flow in reverse flow
direction.
20
7520
7540-7541
(2 regs)
Fwd_LowFlowCutoff
Low Flow cutoff
Forward
For forward flow rates with smaller
magnitude than this cutoff value, totalisers
stop counting and outputs (such as the
frequency output) will be disabled; flow rate
indication will still be available (in m/s).