Yokogawa GC1000 Mark II Process Gas Chromatograph User Manual
Yokogawa Air equipment
Table of contents
Document Outline
- Introduction
- Safety Precautions
- Documentation Conventions
- Copyright and Trademark Notices
- Installing the Maintenance Terminal
- 1. Overview of Maintenance Terminal
- 2. LCD Emulator Window
- 3. Analyzer Operation Window
- 3.1 Starting and Exiting the Maintenance Terminal
- 3.2 Layout of Analyzer Operation Window
- 3.3 Viewing the States of the Detector and Temperature Controller
- 3.4 Changing the User Level
- 3.5 Changing the Status/Operation Mode/Measurement Status
- 3.6 Changing the states of the Valves/Detectors/Temperature Controller
- 3.7 Changing the Range
- 3.8 Changing the Valves and Peak Information
- 3.9 Uploading and Downloading the Parameter Settings
- 3.10 Actions When Alarms Occur
- 4. Chromatogram Window
- 5. Alarm Windows
- 6. Analysis Results Windows
- 6.1 Opening and Closing an Analysis Results Window
- 6.2 Types and Layouts of Analysis Results Windows
- 6.3 Switching Between Analysis Results Windows
- 6.4 Saving and Retrieving Data
- 6.5 Processing and Re-saving Data
- 6.6 Graphing Historical Data
- 6.7 Resetting Historical Data
- 6.8 Opening the Help Window of an Analysis Results Window
- Appendix A Menus
- Appendix B Messages Summary
- Revision Information