Yokogawa GC1000 Mark II Process Gas Chromatograph - Manual (Page 46)

<3. Analyzer Operation Window>
3-17
IM 11B03G03-03E
n Turning On/Off the Temperature Controller
(1) Click on the description of the temperature controller. The Temperature Control Unit
Operation window opens.
Click
F0325.ai
(2) Click on the state under the State/Remark column of the temperature controller of interest. A
confirmation dialog box pops up.
F0326.ai
(3) Click on the [Yes] button. The state marked under the State/Remark column will be changed
to ON or OFF.
3.7 Changing the Range
By using the range table set in the analyzer, the ranges of each peak can be changed. This
section explains how to change the range.
NOTE
The range can be changed only at user levels B or C. This change cannot be made unless the
analyzer is in the Remote mode.
4th Edition : Mar. 21, 2012-00