Watlow PPC-2000 - Manual (Page 91)

PPC-2000 User’s Guide Chapter 2: Hardware Installation
Doc.# 30002-00 Rev 2.3 Watlow Anafaze 67
Connecting Analog Outputs to the PPC-205x
Connect wires directly to the terminals on the bottom of the
PPC-205x modules. The PPC-2050 can source up to eight
analog signals and the PPC-2051 up to four.
Table 2.22 lists the terminal connections for the PPC-2050
module.
Figure 2.54 PPC-205x Connections (Bottom View)
Table 2.22 Analog Output Connections on
Analog Out Module
1.
The AnaWin3 name is shown for the Encoder In Analog Out module with address
11 on the first PPC-2000 in the system. Refer to Outputs on page 135 for a full
explanation of Analog output naming.
Module I/O
Number
Analog Out Module
Connections AnaWin3 Name
(Input
Spreadsheet) 1
Voltage Current
+ - Source Sink
Analog Out 1 1A 1B 1B 1A PPC1:AO 31.1
Analog Out 2 2A 2B 2B 2A PPC1:AO 31.2
Analog Out 3 3A 3B 3B 3A PPC1:AO 31.3
Analog Out 4 4A 4B 4B 4A PPC1:AO 31.4
Analog Out 5 5A 5B 5B 5A PPC1:AO 31.5
Analog Out 6 6A 6B 6B 6A PPC1:AO 31.6
Analog Out 7 7A 7B 7B 7A PPC1:AO 31.7
Analog Out 8 8A 8B 8B 8A PPC1:AO 31.8
PPC-2050 PPC-2051
16-pin Terminal Block
for Analog Outputs