Watlow PPC-2000 - Manual (Page 190)

Chapter 5: LogicPro and Modbus Reference PPC-2000 User’s Guide
164 Watlow Anafaze Doc.# 30002-00 Rev 2.3
The IO Physical Address is constructed from the parameter
number and the database offset.
See the LogicPro User’s Guide for specific instructions on
addressing analog and encoder input parameters.
See Table 5.3 below through Table 5.6 on page 166 for a list of
the database offsets for each analog and counter input. See
Table 5.8 on page 168 for analog input parameter numbers.
Analog Input Numbers and Address Offsets
Table 5.3 below through Table 5.6 on page 166 list the LogicPro
IO Physical Addresses, Database Offsets and sample Modbus
addresses corresponding to each analog and counter input. The
sample Modbus addresses are for the Input Value.
Table 5.3 Addresses for Analog Inputs on the
PPC-202x Modules
1 The AnaWin3 names are shown for the first PPC-2000 in the system. See Inputs on page 127
for a full explanation of analog input naming.
2 Use this address with the Analog_In_202x IO Driver when addressing Input Value.
3 Use this address with the Database IO Driver when addressing input parameters other than
Input Value . Replace the # with the parameter number (#) from Table 5.8 on page 168 for the
parameter you want to address.
AnaWin3 Name 1
(Input Spread-
sheet)
LogicPro I/O Physical Address Modbus Addressing
Analog_In_202x
IO Driver 2
Database
IO Driver 3
Database
Offset
Sample
Address
PPC1:AI 1.1
PPC1:AI 1.2
PPC1:AI 1.32
1.1
1.2
1.32
#.1
#.2
#.32
1
2
32
30801
30802
30832
PPC1:AI 2.1
PPC1:AI 2.2
PPC1:AI 2.32
2.1
2.2
2.32
#.33
#.34
#.64
33
34
64
30833
30834
30864
PPC1:AI 3.1
PPC1:AI 3.2
PPC1:AI 3.32
3.1
3.2
3.32
#.65
#.66
#.96
65
66
96
30865
30866
30896
PPC1:AI 4.1
PPC1:AI 4.2
PPC1:AI 4.32
4.1
4.2
4.32
#.97
#.98
#.128
97
98
128
30897
30898
30928
… … … … …
… … … … …
… … … … …
… … … … …