Watlow PPC-2000 - Manual (Page 84)

Chapter 2: Hardware Installation PPC-2000 User’s Guide
60 Watlow Anafaze Doc.# 30002-00 Rev 2.3
Table 2.19 HD-15 Power Connections
Analog Output Connections
The connector pinouts are shown in Table 2.20. Use 16-28 AWG
wire. When making connections, tighten to 0.5 to 0.6 Nm, or 4.5
to 5.4 inch-pound.
Figure 2.45 PPC-2030 Analog Out Terminal Block
Table 2.20 Analog Output Connections on
Encoder In Analog Out Module
1 The AnaWin3 name is shown for the Encoder In Analog Out module with address
11 on the first PPC-2000 in the system. Refer to Outputs on page 135 for a full
explanation of Analog output naming.
Voltage Pin Number
+5Vdc 12, 15
COM 13, 14
Module I/O
Number
Encoder In Analog
Out Module
Connections
AnaWin3 Name
(Input Spread-
sheet) 1
+ -
Analog Out 1 J1-1+ J1-1- PPC1:EIAO 11.3.1
Analog Out 2 J1-2+ J1-2- PPC1:EIAO 11.3.2
Analog Out 3 J2-3+ J2-3- PPC1:EIAO 11.3.3
Analog Out 4 J2-4+ J2-4- PPC1:EIAO 11.3.4
J2
J1
4-
4+
3-
3+
2-
2+
1-
1+
Outputs 3 & 4
Outputs 1 & 2
DIN Rail Latch