Maple Systems OIT Family - Manual (Page 6)

Installing OITware-200
To install OITware-200:
1. Start Windows. If any applications are running, close them before continuing.
2. Place the OITware-200 Setup Disk into your 3.5-inch floppy drive.
3. Windows95, 98 and NT4.0: From the Task Bar, choose Start, then Run.
Windows 3.x: In Program Manager, from the File menu, choose Run.
4. Type a:\setup (substitute b for a if your 3.5-inch drive is configured as the b drive).
5. Choose the OK button.
6. Follow the instructions on your screen.
NOTE:When installation of OITware-200 is complete, your PC must be restarted before
OITware-200 will operate correctly.
Creating an OITware-200 Project
This step walks you through the creation of a basic OITware-200 project named
SAMPLE.MAP. Once downloaded to the OIT, this basic configuration allows the OIT to
connect to the PLC, display a startup message, and display a message containing one
PLC register monitor when Function Key #1 is pressed.
1. Start OITware-200.
2. From the File menu, choose New. The New Project dialog box appears.
3. In the PLC Type drop down list box, select the appropriate PLC model.
NOTE:It is important to select the correct PLC type. OITware-200 can not transfer a project
from one PLC type to another.
4. In the OIT Type drop down list box, select the appropriate OIT model.
NOTE:If you ever need to convert a project from one OIT type to another, refer to the Export
Project to OIT section in CHAPTER 12: Utilities. The export feature works for all OIT
models except the OIT5400.
5. Choose the Start New Project button. The OIT - Controller Settings dialog box
appears.
Getting Started 6
1010-0099, Rev. 07