Teledyne LeCroy Sierra SAS_SATA Protocol Analyzer STX API Reference Manual - Manual (Page 912)

Sierra SAS/SATA Protocol Suite, STX Software API Reference Manual
ATA Command Pattern parameters 912
FID_ATACOMMAND_SUPPORTED_SECURITY_PROTOCOL_LIST
FID_ATACOMMAND_PADS
FID_ATACOMMAND__PI
FID_ATACOMMAND__UA
FID_ATACOMMAND__INSUFF_NV_CACHE_SPACE
FID_ATACOMMAND__INSUFF_LBA_RANGE_ENTRIES
FID_ATACOMMAND__ATTEMPT_PARTIAL_RANGE
FID_ATACOMMAND__UNCORRECTABLE_OPTIONS
FID_ATACOMMAND__MIN_NUM_OF_LOG_BLOCK
ATA Command Pattern parameters
For ATAPI parameters use SCSI parameters and ATA parameters based on SPEC.
Address Frame Pattern parameters
FID_LINK_ADDRESS_FRAME_TYPE = 0,
FID_LINK_DEVICE_TYPE,
FID_LINK_RESTRICTED,
FID_LINK_SMP_INITIATOR_PORT,
FID_LINK_STP_INITIATOR_PORT,
FID_LINK_SSP_INITIATOR_PORT,
FID_LINK_RESERVED,
FID_LINK_SMP_TARGET_PORT,
FID_LINK_STP_TARGET_PORT,
FID_LINK_SSP_TARGET_PORT,
FID_LINK_SAS_ADDRESS,
FID_LINK_PHY_IDENTIFIER,
FID_LINK_CRC,
FID_LINK_PROTOCOL,
FID_LINK_INITIATOR_PORT,
FID_LINK_CONNECTION_RATE,
FID_LINK_FEATURES,
FID_LINK_INITIATOR_CONNECTION_TAG,
FID_LINK_DESTINATION_SAS_ADDRESS,
FID_LINK_SOURCE_SAS_ADDRESS,