Teledyne LeCroy Sierra SAS_SATA Protocol Analyzer STX API Reference Manual - Manual (Page 196)

Sierra SAS/SATA Protocol Suite, STX Software API Reference Manual
ISerialSCSICaptureProject 196
GetDataConditionExprPatternProtocolType Determines protocol type of
command for added Data pattern
trigger pattern (or expression
pattern of a condition).
GetEntireMemory Returns the entire memory space
for capturing.
GetExcludeALIGN Shows whether Exclude ALIGN
attribute is set or not.
GetExcludeCONT Shows whether Exclude CONT
attribute is set or not.
GetExcludeIdle Shows whether Exclude Idle
packets attribute is set or not.
GetExcludeNOTIFY Shows whether Exclude NOTIFY
attribute is set or not.
GetExcludeOOBSignals Shows whether Exclude OOB
signals is set or not.
GetExcludePayloadOffset Returns Exclude payload offset
value.
GetExcludeRRDY Shows whether Exclude RRDY
attribute is set or not.
GetExcludeSYNC Shows whether Exclude SYNC
attribute is set or not.
GetExcludeXXXX Shows whether Exclude XXXX
attribute is set or not.
GetExerciserInterface Returns the interface of exerciser.
GetExistStateId Returns all state IDs that exist in
the project in advanced mode.
GetLastErrorStateId Returns state ID of state where
error occurred. (error code
returns by Run method)
GetNumberOfCapturePatterns Returns the number of Capture
patterns (based on StateId).
GetNumberOfCondition Returns number of conditions
that can be defined in each state.