Teledyne LeCroy Sierra SAS_SATA Protocol Analyzer STX API Reference Manual - Manual (Page 517)

Sierra SAS/SATA Protocol Suite, STX Software API Reference Manual
IExerciserEngine 517
Properties
Properties Name Properties Description
ALIGNTransmissionPeriod Defines the duration of ALIGN
transmission in DWORD increments.
Maximum value is 4095.
ATACommandExecutionTimeout Determines the maximum time for
execution of an ATA command in a
device. After this time, the device is
reset.
Board1ExrPort Specifies in which port exerciser or
pattern generator must be run for first
board.
Board1ExrSpeed Shows speed of exerciser for first board.
See SpeedEnum
Could be used in set exerciser or pattern
generator in I1, T1 or I2, T2.
Board2ExrPort Specifies in which port exerciser or
pattern generator must be run for
second board.
Board2ExrSpeed Shows speed of exerciser for second
board.
See SpeedEnum
Could be used in set exerciser or pattern
generator in I3, T3 or I4, T4.
BusInactivityTimeLimit Contains the maximum period that an
SSP target port is permitted to maintain
a connection without transferring a
frame to the SSP initiator port.
This value is the number of 100-µs
increments between frames that the SSP
target port transmits during a
connection. A value of zero in this field
specifies that there is no bus inactivity
time limit.
NOTE: Use only in SAS software.
ContUsage Specifies use cont for repeating primitive
or not.
NOTE: Use only in SATA software.