Teledyne LeCroy Sierra SAS_SATA Protocol Analyzer STX API Reference Manual - Manual (Page 631)

Sierra SAS/SATA Protocol Suite, STX Software API Reference Manual
ITargetEmulEngine 631
SetCOMWAKEBurstCount Sets COM WAKE burst count value for a
SATA device.
GetCOMWAKEBurstCount Returns COM WAKE burst count value for
a SATA device.
SetIgnoreIncomingCOMWAKE Sets ignore incoming COM WAKE for a
SATA device.
GetIgnoreIncomingCOMWAKE Returns ignore incoming COM WAKE for a
SATA device.
SetIgnoreIncomingCOMINIT Sets ignore incoming COM INIT for a SAS
or SATA device.
GetIgnoreIncomingCOMINIT Returns ignore incoming COM INIT for a
SAS or SATA device.
SetIgnoreIncomingCOMSAS Sets ignore incoming COM SAS for a SAS
device.
GetIgnoreIncomingCOMSAS Returns ignore incoming COM SAS for a
SAS device.
SetNumberOfWritableAreas Sets number of Memory Map writable
sections of simulated media.
GetNumberOfWritableAreas Returns number of Memory Map writable
sections of simulated media.
SetAddressOfWritableArea Sets start address memory of a writable
section of simulated media.
GetAddressOfWritableArea Returns start address memory of a
writable section of simulated media.
AddUserDefineCommand Adds a user-defined command for a SAS
or SATA device.
DeleteUserDefineCommand Removes a user-defined command from a
SAS or SATA device.
SetUserDefineCommand Changes attribute of a user-defined
command for a SAS or SATA device.
SetMuxingEnabled Enables/Disables Muxing for current port.
GetMuxingEnabled Returns Muxing status. (Enable or Disable)