Teledyne LeCroy Sierra SAS_SATA Protocol Analyzer STX API Reference Manual - Manual (Page 199)

Sierra SAS/SATA Protocol Suite, STX Software API Reference Manual
ISerialSCSICaptureProject 199
RemoveAssignedResource If direction of a pattern changes,
call this function and then set
direction and all parameters.
After that, call
UpdateHardwareResource
function.
RemoveCapturePattern Removes a Pattern from Capture
(based on StateId), specified by its
index, and returns the result.
RemoveConditionExprPattern Removes a Pattern from an
expression for a condition in
advanced mode, or trigger items
in easy mode, specified by its
index, and returns the result.
RemoveState Removes a state from project in
advanced mode.
Run Starts a capture.
Save Saves the current project with the
file name.
SetAddressFrameCapturePattern Sets the Address frame type for
added Address Frame capture
pattern.
Note: When added Address frame
pattern default Type is Any Type,
this method can change type of
Address frame and parameters.
SetAddressFrameConditionExprPattern Sets the Address frame type for
added Address Frame trigger
pattern (or expression pattern of
a condition).
Note: When added Address frame
pattern default Type is Any Type,
this method can change type of
Address frame and parameters.
SetATACommandCapturePattern Sets the ATA Command type for
an added ATACommand capture
pattern.
SetATACommandCapturePatternLBAMode Sets the ATA Command capture
pattern mode to CHS or LBA.