Teledyne LeCroy Sierra SAS_SATA Protocol Analyzer STX API Reference Manual - Manual (Page 518)

Sierra SAS/SATA Protocol Suite, STX Software API Reference Manual
IExerciserEngine 518
DataFramePayloadSize Shows payload size of data frame.
ExerciserPhyResetSetting Shows that PHY reset sequence and
identification is done if required with
Zero value or in each Run with one value.
FirstBurstSize If the ENABLE FIRST BURST field in the
COMMAND frame is set to one, this field
contains the maximum amount of write
data in 512-byte increments that may be
sent using the SSP initiator port to the
SSP target port without having to receive
an XFER_RDY frame from the SSP target
port.
For example, a value of one in this field
means that the number of bytes
transferred using the SSP initiator port is
less than or equal to 512.
A value of two in this field means that
the number of bytes transferred using
the SSP initiator port is less than or equal
to 1024.
NOTE: Use only in SAS software.
LogicalBlockSize Transfer length of read and write
commands must be a multiple of this
value.
MaximumConnectTimeLimit Contains the maximum duration of a
connection.
This value is the number of 100-µs
increments that an SSP target port
transmits during a connection, after
which the SSP target port prepares to
close the connection.
A value of zero in this field specifies that
there is no maximum connection time
limit.
NOTE: Use only in SAS software.