Teledyne LeCroy Sierra SAS_SATA Protocol Analyzer STX API Reference Manual - Manual (Page 393)

Sierra SAS/SATA Protocol Suite, STX Software API Reference Manual
IExerciserEngine 393
SetOOBInstrCount Sets count of OOB setting for an OOB
type.
SetOOBInstrIdleTime Sets Idle time of OOB setting for an
OOB type.
SetOOBInstrIgnore Sets mode of OOB (Ignore/Accept)
setting for an OOB type.
SetOOBInstrNegationTime Sets Negation time of OOB setting for
an OOB type.
SetOOBInstrSATAPortSelectionT1 Sets SATA port selection T1 in OOB
setting.
SetOOBInstrSATAPortSelectionT2 Sets SATA port selection T12 in OOB
setting.
SetOOBInstructionSyncState Sets Synchronization state of an OOB
instruction:
send after completion of previous
block or
send immediately.
SetOOBInstructionType Sets type of an OOB instruction:
normal OOB or SATA port selection.
SetPacketRetryNumber Sets Retry Number attribute of a
packet.
SetPrimitiveInstructionCount Sets count value of a primitive
instruction.
SetPrimitiveInstructionType Sets type of a primitive instruction:
SSP-SMP, STP, or not specific to
connection.
SetPrimitiveInstructionValue Sets primitive value of a primitive
instruction
(see PrimitivesEnum ).
SetSATAPowMngInstructionType Sets type of SATA power
management instruction
(see PowMngInstrEnum )
SetSATASelfTestFieldDataToDBId Sets datablock ID to a field of a STA
self-test instruction.