Teledyne LeCroy FireInspector - Users Manual - Manual (Page 44)

34
CATC F IRE I NSPECTOR 2.01 C HAPTER 4
User’s ManualRecording 1394 Traffic
To change the counter values:
Step 1
Click on the light blue circle in the upper left corner of a Count box.
A menu will pop up.
Step 2 Select Change Counter Value.
The Input Counter Value dialog will open.
Step 3 Enter a value between 1 and 15.
Step 4
Click OK.
The new value will be displayed in parentheses on the Count box.
Event to Event Sequencing
When an event is sequenced to another event, the recording engine waits for the first event
to happen and then enables the second event for triggering. Note that an event can be
sequenced to another event only if the second event is designated as a trigger or to generate
external output only, and both are header-type events.
Enable/Disable External General Purpose Output
This option enables or disables an event's ability to generate an output signal on one of the
external interface breakout board output pins. When this option is enabled, the event can
generate the external output as well as being associated with another action.
To Enable or Disable External General Purpose Output:
Step 1
Click on the light blue circle in the upper left corner of an event box.
A menu will pop up.
Step 2
Select Enable External General Purpose Output or Disable External General
Purpose Output.
If external output is enabled, a small magenta arrow will protrude from the lower right side
of the event box. If external output is disabled, the arrow will disappear.
Enable External General Purpose Output Only
This option enables an event's ability to generate an output signal on one of the breakout
board output pins and disassociates it from all other actions and events. When this option is
enabled, the event will only generate external output.
To enable External General Purpose Output Only:
Step 1
Click on the light blue circle in the upper left corner of an event box.
A menu will pop up.
Step 2
Select Enable External General Purpose Output only.
If external output is enabled, a small magenta arrow will protrude from the lower right side
of the event box. If the event was previously associated with an action or other event, those
associations will be removed.