Teledyne LeCroy FireInspector - Users Manual - Manual (Page 19)

9
CATC F IRE I NSPECTOR 2.01 C HAPTER 1
User’s ManualFireInspector Overview
record 1394 bus traffic, a separate FireInspector application installation for Windows
NT 4.0 is required.
• Required setup: Microsoft Internet Explorer 4 or later must be installed.
• Processor: For optimum performance, use processors of the Intel® Pentium® III or
Pentium 4 family, the AMD® Athlon® or Duron® family, or other compatible proces-
sors with clock speed of 500mHz or higher. Must have, as a minimum, a processor from
the Intel Pentium II or Celeron® family, AMD-K6® family, or equivalent with clock
speed of 300mHz.
• Memory: For the best performance, it is recommended to have physical RAM twice the
size of the recording buffer setup – 256 MB or more (minimum of 64 MB of RAM).
• Hard disk: At least 20 MB of free hard disk space is required for the installation. Addi-
tional disk space is needed for storing the recorded data in files during the recording
process (can be as much as 128 MB when recording a full buffer size).
• Display: Resolution of 1024 x 768 with at least 16-bit color is recommended (resolution
of 800 x 600 with 16-bit color is a minimum).
• Connectivity: A USB interface is required to connect the host computer to the FireIn-
spector analyzer box. This is not a requirement if the FireInspector application is going
to be used only as a Trace viewer.
• If Windows NT drivers are used, the computer should have the Windows NT 4.0 operat-
ing system with Service Pack 1 or later installed.
Note: Please contact CATC for information about controlling the FireInspector analyzer from a computer
using Windows NT 4.0.