Teledyne LeCroy FireInspector - Users Manual - Manual (Page 40)

30
CATC F IRE I NSPECTOR 2.01 C HAPTER 4
User’s ManualRecording 1394 Traffic
Step 2 Select the Events tab.
Step 3 Choose one or more event groups from the list and set the parameters, which
will appear to the right of the list when you click on an event group name.
See “Event Groups” on page 30 for details about the event groups and
parameter settings.
When parameters are set for a selected event, a check mark will appear in the
checkbox next to the event's name in the Event Groups list, and the event will
be shown on the Actions tab of the Recording Options dialog.
Note: Due to analyzer resource limitations, some event names may become grayed
out (meaning that they're currently unavailable) when others are
checkmarked.
Step 4 Click OK to apply the settings and close the Recording Options dialog.
Event Groups
Note: If hardware resources have already been allocated for other events, the number of possible parameter
selections may be limited. The descriptions below note the maximum number of selections.
• Transaction codes: Choose up to three transaction code types from the Transaction
Codes list.
• Destination/source IDs: Enter up to two sets of destination and source IDs. Only the six
right-most bits can be used. The IDs should be entered in hexadecimal, and they should
fall within the range 0-3F. It's not necessary to enter both the destination and source IDs;
if just one is entered, then the other is considered to be a “don't care.”
• Destination offset: Define up to two destination offsets. The offsets should be entered in
hexadecimal. It's not necessary to enter both the high and low bits; if just one is entered,
then the other is considered to be a “don't care.”
Figure 4-2: Recording Options dialog: event options