Teledyne LeCroy FireInspector - Users Manual - Manual (Page 24)

14
CATC F IRE I NSPECTOR 2.01 C HAPTER 2
User’s ManualGetting Started
Note: The FireInspector analyzer box must be attached to the computer via the USB cable and powered on
before updating the driver.
2.5.1 Updating the Driver on Windows 2000
Step 1
Select Start > Settings > Control Panel from the desktop taskbar, then
double-click on Add/Remove Hardware in the Control Panel window.
The Add/Remove Hardware Wizard will open.
Step 2
Click Next.
Step 3
Choose “Uninstall/Unplug a device” and click Next.
Step 4
Choose “Unplug/Eject a device” and click Next.
Step 5
Select CATC FireInspector IEEE 1394 Bus Analyzer from the list of devices
and click the Properties button.
The Properties window will open.
Step 6 Select the Driver tab in the Properties window and click Update Driver.
The Upgrade Device Driver Wizard will open.
Step 7
Click Next.
Step 8
Choose “Display a list of the known drivers for this device so that I can
choose a specific driver.” Then, click Next.
Step 9
Choose “Have disk” and click Next.
The Install from Disk window will open.
Step 10
Install from Disk 1 of the FireInspector installation diskette set:
Make sure that the disk is in the computer’s floppy drive, then select the drive
from the drop-down list or type the drive letter (e.g., “a:”) in the combo box,
then click OK.
Install from a directory on the computer’s hard drive:
Browse or enter the path to the Disk 1 directory of the FireInspector
installation, then click OK.
The Install from Disk window will close.
Step 11
Select CATC FireInspector IEEE 1394 Bus Analyzer from the list of devices
in the Upgrade Device Driver Wizard and click Next.
Step 12 Click Next to install the driver.
Step 13 Click Finish to close the Wizard.
Step 14
Check the driver version on the Driver tab of the Properties window to make
sure that the driver was successfully upgraded.
Step 15
Close the remaining open windows.
2.5.2 Updating the Driver on Windows 98 SE
Step 1 Select Start > Settings > Control Panel from the desktop taskbar, then
double-click on System Properties in the Control Panel window.
The System Properties window will open.