Teledyne LeCroy PeRT3 Phoenix System - Manual (Page 87)

Teledyne LeCroy PeRT
3
Phoenix System User Manual 85
Creating a New Test Pattern Teledyne LeCroy
The default name for the new pattern is “New Pattern". This name can be changed by
selecting the new pattern in the Main Library (it will be at the bottom of the list) and
clicking on the Rename the Selected Item icon in the Main Library window
toolbar.
Pattern Editor Tab Controls
The Pattern tab contains seven panels, which allow the user to create new patterns and
edit existing patterns. These panels are Master, Display Mode, Standard Edit, Pattern
Edit, Import/Export, View Info and Notifications. Each of these panels is described
below.
Master Controls
The Master Controls panel provides controls to start and stop a test, and to connect and
disconnect to the DUT. The four numbered indicators light to show which channel(s) are
being tested.
Figure 9.3: Master Controls Panel
Display Mode
The Display Mode panel allows the user to specify the protocol to be used when
decoding frames, the width of the data display, the direction for data display, and the
format for the pattern data.
Figure 9.4: Display Mode Panel