Teledyne LeCroy PeRT3 Phoenix System - Manual (Page 27)

Teledyne LeCroy PeRT
3
Phoenix System User Manual 25
Introduction Teledyne LeCroy
Once the test is selected, the test can be started by clicking the Start (record results)
button in the Master Controls panel.
Once the test is running, the Stop button will become active, and can be used to stop the
test. The indicators to the immediate right of these buttons (marked "1", "2", "3", and
"4") refer to the four channels which can be tested simultaneously. If a channel is active,
the indicator corresponding to that channel will be lit. In addition, a summary of error
results is provided for each channel in the status screen in the center of the Master
Controls panel.
In addition, as the test is running, the Output window at the bottom of the main
application window will provide a log of test conditions and results.
If the test was started with the Start (record results) button, the results are automatically
saved in the Test Results library while the test is running.
An alternate way to select and run a test is to click on the test within the Test Scripts tab
of the Main Library window, then either click the Run Test icon at the top of the window
or right‐click on the test name and select Run Test.