Teledyne LeCroy PeRT3 Phoenix System - Manual (Page 114)

Teledyne LeCroy Safety Compliance
112
112
2. Emissions which exceed the levels required by this standard may occur when the
instrument is connected to a test object.
3. This product is intended for use in nonresidential areas only. Use in residential areas
may cause electromagnetic interference.
4. Meets Performance Criteria "B" limits of the respective standard: during the
disturbance, product undergoes a temporary degradation or loss of function or
performance which is self‐recoverable.
5. Performance Criteria "C" applied for 70%/25 cycle voltage dips and for 0%/250 cycle
voltage interruption test levels per EN61000‐4‐11.
European Contact:
Teledyne LeCroy Europe GmbH
Waldhofer Str 104
D‐69123 Heidelberg
Germany
Tel: (49) 6221 82700
AUSTRALIA & NEW ZEALAND DECLARATION OF CONFORMITY - EMC
Instrument complies with the EMC provision of the Radio Communications Act per the
following standards, in accordance with requirements imposed by Australian
Communication and Media Authority (ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in accordance with
EN61326‐1:2006 and EN61326‐2‐1:2006.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia
Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC DECLARATION OF CONFORMITY - LOW VOLTAGE
The instrument meets intent of EC Directive 2006/95/EC for Product Safety. Compliance
was demonstrated to the following specifications as listed in the Official Journal of the
European Communities:
EN 61010‐1:2010 Safety requirements for electrical equipment for measurement,
control, and laboratory use ‐ Part 1: General requirements