Teledyne LeCroy PeRT3 Phoenix System - Manual (Page 26)

24
Teledyne LeCroy Introduction
Selecting and Running a Test
To run a predefined test, select the test from the list of tests that appears in the drop
down menu in the Master Controls panel in the top left of the PeRT
3
main application
window.
The Master Controls panel also contains a set of icons which can be used to control the
selected test script.
These button are explained below (from left to right).
Start (don’t record)
Start test without recording Disconnect
Disconnect from device under
test
Start (Record results)
Start test and record results
Indicator (s) #1, #2, #3, #4
Green Pattern Lock
Yellow Signal Lock
Orange Signal Detect
Red No Signal
Stop
Stop current test
Inject Error
Inject a bit error on active
channels
Connect
Connect to and initialize
device under test Reset Counters
Reset bit and error counts to
zero
Note: The difference between Start (don’t record) and Start (record results) is whether the user can
change any of the jitter settings while the test is running. Start(don’t record) will allow the change,
but Start(record results) will not. This is useful during initial test development to quickly
determine how the device under test behaves under different conditions.