Teledyne LeCroy PeRT3 Phoenix System - Manual (Page 115)

Teledyne LeCroy PeRT
3
Phoenix System User Manual 113
113
Environmental Compliance Teledyne LeCroy
EN 61010‐2:030:2010 Safety requirements for electrical equipment for measurement,
control, and laboratory use ‐ Part 2‐030: Particular requirements for testing and
measuring circuits
The design of the instrument has been verified to conform to the following limits put
forth by these standards:
 Overvoltage Category II: this refers to equipment intended to be supplied from
the building wiring with a nominal supply voltage up to 300V.
 Measurement Category O: this refers to instrument measurement terminals that
are not intended to be directly connected to the MAINS supply.
 Pollution Degree 2: this refers to an operating environment where normally only
dry, non‐conductive pollution occurs. Occasionally a temporary conductivity
that is caused by condensation must be expected. This location is a typical
office/home environment.
 Protection Class I: this refers to grounded equipment, in which protection
against electric shock is achieved by Basic Insulation and a connection to the pro‐
tective ground conductor in the building wiring.
U.S. NATIONALLY RECOGNIZED AGENCY CERTIFICATION
The instrument has been certified by Underwriters Laboratories (UL) to conform to the
following safety standard and bears UL Listing Mark:
UL 61010‐1 Third Edition ‐ Safety standard for electrical measuring and test equipment.
CANADIAN CERTIFICATION
The instrument has been certified by Underwriters Laboratories (UL) to conform to the
following safety standard and bears cUL Listing Mark:
CAN/CSA‐C22.2 No. 61010‐1‐12. Safety requirements for electrical equipment for
measurement, control and laboratory use.
Environmental Compliance
END-OF-LIFE HANDLING
The instrument is marked with this symbol to indicate that it complies with the applicable
European Union requirements to Directives 2002/96/EC and 2006/66/EC on Waste
Electrical and Electronic Equipment (WEEE) and Batteries.