Histograms, Creating and viewing a histogram, Single parameter histogram setup – Teledyne LeCroy WaveRunner XI SERIES Operator’s Manual User Manual
Page 87: From measure dialog, Istograms

O
PERATOR
’
S
M
ANUAL
4. Touch
inside
the
Source1 field and select an input waveform from the pop-up menu.
5. Touch
inside
the
Measure field and select a parameter from the pop-up menu.
6. Touch
the
Track button
at the bottom of the dialog; then, from the
Math
menu, select a math function location (F1 to Fx The number of math traces available
selection for Track
depends on the software
See specifications.) to store the Track display. The Track will be
options loaded on your oscilloscope.
WRXi-OM-E Rev C
87
displayed along with the trace label
Example Track Trace Label for the math function you
splayed Track math function trace label if you want to change any settings in the
Track
selected.
7. Touch the newly di
dialog:
HISTOGRAMS
Creating and Viewing a Histogram
Note: The number of sweeps comprising the histogram will be displayed in the bottom line of the trace
descriptor label:
Single Parameter Histogram Setup
F
ROM
M
EASURE
D
IALOG
1. In the menu bar, touch
Measure, then Measure Setup.
2. Touch
the
My Measure button.
3. Touch one of tabs
P1 through Px.
field and select an input waveform from the pop-up menu.
arameter from the pop-up menu.
ting histogram, then close the pop-up menu.
8. Touch the math trace label for the math trace you just created.
4. Touch
inside
the
Source1
5. Touch
inside
the
Measure field and select a p
6. Touch
the
Histogram button at the bottom of the dialog.
7. Touch a math trace in which to place the resul