Teledyne LeCroy WaveRunner XI SERIES Operator’s Manual - Manual (Page 124)

W
AVE
R
UNNER
X
I
S
ERIES
124
WRXi-OM-E Rev C
Parameter Description Definition Notes
TAA Average peak-to-trough
amplitude for all local features.
om noise
Hysteresis argument used to
discriminate levels fr
in data.
Available with DDM2 option.
Standard in DDA-5005A.
TAA- Average local baseline-to-
trough amplitude for all local is argument used to
m noise
features.
Hysteres
discriminate levels fro
in data.
Available with DDM2 option.
Standard in DDA-5005A.
TAA+ Average local baseline-to-peak
amplitude for all local feature . to
noise
ption.
Standard in DDA-5005A.
s
Hysteresis argument used
discriminate levels from
in data.
Available with DDM2 o
TIE@level
pe and level and the
Slope
ositive,
ut
e or
unit interval
You can also use a
mathematically derived Golden
PLL to filter low frequency jitter.
Cutoff Freq = (1/1.667e3) x
Clock Freq Reference levels and edge-
transition polarity can be
selected. Hysteresis argument
used to discriminate levels
from noise in data.
Available with JTA2 and
XMAP options.
Difference between the
measured times of crossing a
given slo
ideal expected time. For
you can choose p
negative, or both. For outp
units you can choose tim
unit interval (UI). A
equals one clock period.
The Virtual Clock setup gives
you a choice of Standard
(1.544 MHz) or Custom
reference clocks.
The cutoff frequency is user
selectable.
Time@level ger
(t=0) to crossing at a specified
level.
Time from trigger to crossing
level
ent
vels
Time at level: Time from trig Reference levels and edge-
transition polarity can be
selected. Hysteresis argum
used to discriminate le
from noise in data.
Standard parameter.